- There will be no problems such as burning, driblet formation (melting), hardening and deformation that may be caused by thermal reasons as waterjet is a cold process.

- Material pairs with different burning or melting temperatures that cannot be cut by using laser and sandwich materials can be cut with waterjet.

- No chemical pollution forms during the process, as there is no material burning or melting.

Thanks to this advantage, there is no need for an additional investment such as gas absorption, refinery and filtration.

- Material loss is decreased to minimum level, as cutting trace interval is very narrow (max. 1.1 mm).

- It is possible to process (cut) very narrow and sharp corners depending on the phase diameter of the water-jet, which is the cutting component.

- All honeycomb-textured materials that cannot be cut by using other methods can be cut with water-jet.

- No burrs occur at the bottom or top side in the section cut by waterjet, thus no additional grinding or leveling is required.

 
- Very thin materials can be cut, as there is no risk for melting or burning.

- A material can be cut immediately after another one is completed by using the same cutting equipment without making any change but the cutting speed, therefore there is no time loss for setting the machinery and equipment especially in tailor cuts.

- No cutting defects occur because of the distance control errors especially in three-dimensional (cubic) cutting, as the tolerance between the material and cutting edge is relatively bigger.

Water-jet cutting technology is not yet a widely used cutting method in spite of this wide operating (cutting) spectrum, however its usage in the world and Turkey has been fastly increasing.
 

In marble, granite and ceramic sector, water-jet is used in cutting different-colored plates and tiles into all kinds of forms and getting them together side by side or telescopically as a puzzle.

Therefore it is possible to manufacture floor rosettes, floor or wall borders, table trays, washbasin or kitchen counter ornamentations in every kind of forms and patterns.
Thanks to the possibility of cutting all types of materials with by using waterjet, it is possible to make productions and designs with unusual architectural concepts by combining metals, natural stones, glass, wood and artificial materials. It is also used in application for manufacturing table legs or table plates in furniture sector (coffee table, etc. production).

Production difficulties that partially restrict especially modern sculpture design can be significantly eliminated thanks to waterjet. Regardless from the material to be used or the requested form, all the designed details can be obtained by cutting from the related materials.